 |
|
|
Installation Guide
This product has been designed to fit MOST 60mm (2-3/8”) and 75mm (2-7/8”) poles and seats. ALL fittings are a neat fit into the pole. The pole may require cleaning prior to inserting the Wave Master® seat support to remove any salt build up or corrosion inside the pole. Ensure that the top of the pole is free of dents and sharp edges as this may affect the correct fitting and/or installation of the Wave Master® seat support. All items of the Wave Master® seat support are to be assembled with light oil e.g. WD40 or CRC or similar. Please note that this product will raise the seat height by approximately 150mm (6”)
. Remember to store all the remaining sleeves etc. in a safe place so that you can access them when needed.
MAXIMUM RECOMMENDED LOAD 120kg (265lbs).
Wave Master® will not be held accountable for the incorrect fitting and/or incorrect use of the supplied product or any damages that may be resultant from these actions. The Wave Master® seat support DOES NOT eliminate any of the risks associated with boating. Safe boating practices should be adhered to at ALL times.
|
 |
| |
HAVE A SAFE AND ENJOYABLE DAYS FISHING WITH THE WAVE MASTER® SEAT SUPPORT |
| |
|
|
|
| |
| 1. Remove the Wave Master® seat support from its packaging |
| 2. Remove the small sleeve from the top (using the supplied allen key) of the Wave Master® seat support |
| 3. Remove the seat from the pole and the plastic cap from the top of the pole |
| |
|
|
|
Installation for a 60mm (2-3/8”) grooved or straight pedestal
|
| 1. Disconnect the existing seat from the pedestal |
| 2. Spray inside post and stem of Wave Master® unit |
| 3. Push Wave Master® firmly into position inside seat post |
| 4. Locate the seat adapter with best fit |
| 5. Insert on Wave Master® |
| 6. Secure with set screw |
| 7. Install seat connection onto Wave Master® |
| 8. Go Boating with safety and comfort |
|
|
|
|
Installation for a 75mm (2-7/8”) straight pedestal
| 1. Disconnect the existing swivel from the pedestal |
| 2. Locate the pedestal adapter with best fit |
| 3. Spray inside post, adapter and stem of Wave Master® unit |
| 4. Push firmly into position inside pedestal |
| 5. Insert the Wave Master® into the pedestal |
| 6. Locate the seat adapter with best fit |
| 7. Insert on Wave Master® |
| 8. Secure with set screw |
| 9. Install seat connection onto Wave Master® |
| 10. Go Boating with safety and comfort |
| |
|
|
